HCS01.1E-W0009-A-02-B-ET-EC-NN-L4-NN-FW 9A 230V STO SBC Drive

The HCS01.1E-W0009-A-02-B-ET-EC-NN-L4-NN-FW targets compact motion axes that require the 9 A current class and the lower 02 mains-voltage class. It combines a BASIC control section, MultiEthernet communication and multi-encoder feedback with the L4 safety configuration in a narrow IP20 housing.

Its key distinction is the combination of 110 to 230 V-class supply capability and L4 Safe Torque Off plus Safe Brake Control. This makes it materially different from the W0009 NN version and from 03-voltage-class drives. Supply phase arrangement, motor voltage, braking circuit and firmware must all be checked against the original machine before use.

Key Features

· 9 A maximum and 3 A continuous-current reference

· 02 mains-voltage class for 110 to 230 V applications

· BASIC control with ET MultiEthernet

· EC multi-encoder feedback

· L4 Safe Torque Off and Safe Brake Control

· 50 mm nominal cabinet width for compact installations

Typical Applications

· Small servo axes on 230 V-class machines

· Compact packaging equipment

· Assembly and test stations

· Brake-equipped axes requiring the exact L4 configuration

Compatibility and Selection Note

Do not replace an A-02 drive with an A-03 drive based only on current. Confirm the incoming supply, motor data, external mains components, L4 wiring, firmware and material number R911331620.

Frequently Asked Questions

Q1 What does the 02 voltage code identify?

It identifies the lower 110 to 230 V mains-voltage class. The permitted single-phase or three-phase arrangement must be checked for the planned load and installation.

Q2 Does this W0009 model include brake safety?

Yes. The L4 code identifies Safe Torque Off and Safe Brake Control in this exact configuration.

Q3 Can it replace the W0009 NN version?

Only after the complete electrical and safety design is reviewed. The current class is the same, but the safety hardware and wiring are different.

Q4 Which motor feedback can be used?

The EC interface supports multiple encoder families. Confirm the exact motor encoder, cable and firmware support before commissioning.

Q5 Is the MultiEthernet protocol fixed at the factory?

The ET hardware supports several industrial Ethernet options, but the usable protocol is determined by firmware and configuration.

Q6 What information should accompany a quote request?

Provide the full order code, R911331620, the firmware code, the motor model and a clear nameplate photo.