Highlight:
Product Family: |
Lexium 62 Modular Multi-axis Servo System |
Product Type: |
DC Link Terminal Accessory |
Maximum Continuous Current: |
120 A |
Primary Function: |
External Connection Point For The Lexium 62 DC Link |
Flexible Conductor Range: |
10 To 35 Mm² |
Rigid Conductor Range: |
10 To 50 Mm² |
Mounting Position: |
Left Or Right Side Of The Applicable Module Group |
Mechanical Support: |
Strain-relief Provision Included |
Motor Control Function: |
None; Passive Connection Accessory |
Communication Interface: |
None |
Control Supply: |
Not Applicable |
Selection Basis: |
Bus Current, Conductor Type, Cable Cross-section, And Topology |
Installation: |
Lexium 62 Cabinet System By Qualified Personnel |
Safety Consideration: |
Observe DC Bus Discharge And Lockout Procedures |
System Context: |
Lexium 62 Shared DC Link Distribution |
LXM62LT00A01000 Lexium 62 120A DC Link Terminal
The LXM62LT00A01000 is the dedicated DC link terminal for Lexium 62 system wiring. It provides a rated connection point for high-current DC bus conductors and supports up to 120 A continuous current when installed within the specified conductor and cabinet rules.
The terminal accepts defined flexible and rigid conductor ranges and can be positioned on the left or right side of the applicable module group. Its role is electrical connection and strain management; it does not supply power, control a motor, or communicate on SERCOS III.
Key Features
· 120 A maximum continuous DC link current rating
· Flexible conductor range from 10 to 35 mm²
· Rigid conductor range from 10 to 50 mm²
· Left-side or right-side mounting flexibility
· Integrated strain-relief provision for secure cable routing
· Purpose-built interface for Lexium 62 DC link distribution
Typical Applications
· External DC bus connections in Lexium 62 cabinets
· Connection between engineered module groups
· High-current shared-bus distribution and cabinet routing
· Service replacement of a matching Lexium 62 terminal assembly
Compatibility and Selection Note
| Choose conductor material, cross-section, insulation class, ferrules, torque, routing, protection, and strain relief from the approved installation instructions. Confirm bus current, terminal position, connector orientation, clearances, and discharge procedure; this terminal is not a generic DC connector. |
LXM62LT00A01000 | FAQ AND SEO
FAQ
1. Is LXM62LT00A01000 a servo drive?
No. It is a passive DC link terminal accessory and has no motor-control output stage.
2. What is its maximum continuous current?
The terminal is rated for up to 120 A continuous current when installed under the specified conditions.
3. Which cable sizes does it accept?
The listed range is 10 to 35 mm² for flexible conductors and 10 to 50 mm² for rigid conductors.
4. Can it be mounted on either side?
Yes. The accessory is designed for left-side or right-side positioning within the applicable Lexium 62 arrangement.
5. Does it require a SERCOS address?
No. It is an electrical connection component and has no communication interface.
6. What is the main installation risk?
The DC link can retain dangerous voltage. Qualified personnel must follow discharge, verification, conductor preparation, torque, and lockout procedures.
Your message must be between 20-3,000 characters!
