ELAU SH100/40060/0/1/00/00/00/11/00 5.8Nm Keyed Shaft Multiturn Brake PacDrive Servo Motor

The ELAU SH100/40060/0/1/00/00/00/11/00 is a 100 mm-frame permanent-magnet three-phase synchronous servo motor for PacDrive motion systems. The SH100/40060 motor body provides 5.8 Nm standstill torque and 18.3 Nm peak torque. At the documented 400 V operating point, it delivers 4.6 Nm rated torque at 4000 rpm with 1.93 kW rated output.

This complete suffix identifies the keyed shaft, SinCos SKM36 multiturn absolute feedback, and a version with a holding brake, with angular round connectors. It is suited to keyed transmission axes that require repeatable absolute positioning plus a brake for stationary load retention. This combination is distinct from other SH100/40060 variants: the keyed shaft, multiturn encoder, and holding-brake combination identified by the complete suffix. Use the full legacy type code and the mapped SH3 reference SH31002P12F2000 when checking a replacement.

Key Features

· 5.8 Nm standstill torque and 18.3 Nm peak torque for dynamic PacDrive axes

· 1.93 kW rated output at the documented 400 V operating point

· Keyed shaft for the specified mechanical coupling arrangement

· SinCos SKM36 multiturn absolute feedback for motor commutation and position control

· Holding brake included to match the machine's load-holding design

· Mapped SH3 reference SH31002P12F2000 helps verify the exact legacy configuration

Typical Applications

· Keyed gear and pulley drives

· Vertical cartoner and loader axes

· Synchronized material-handling stations

· Intermittent-motion packaging equipment

· Replacement of matching SH100/40060 brake motors

Compatibility and Selection Note

Select the motor by the complete type code SH100/40060/0/1/00/00/00/11/00, not only by SH100/40060. Confirm the shaft interface, encoder type, brake, connector orientation, sealing, motor cable, drive current rating, controller project, and machine mounting arrangement. The mapped reference SH31002P12F2000 supports configuration checking but does not remove the need to compare the installed nameplate and connector layout. Do not substitute another suffix without checking mechanical fit, feedback compatibility, and brake wiring.

FAQ

Is this interchangeable with the smooth-shaft /11 version?

No direct assumption should be made. The torque class is the same, but the shaft interface is keyed rather than smooth, so the coupling and mechanical assembly must be checked.

Which shaft configuration does this exact model use?

It uses a keyed shaft. The coupling, hub, key, axial retention, and permitted shaft loads must match this mechanical version.

What feedback device is specified?

The exact configuration uses SinCos SKM36 multiturn absolute feedback. The controller project and feedback interface must be checked before replacement.

Does this model include a holding brake?

Holding brake included. A holding brake is intended for stationary load retention and is not a service brake for repeatedly stopping a moving axis.

Can this SH motor operate without a compatible servo drive?

No. It is a synchronous servo motor and requires a compatible PacDrive servo amplifier, correctly sized motor cable, feedback connection, motor data, and controller configuration.

What should be verified before ordering a replacement?

Compare SH100/40060/0/1/00/00/00/11/00, cross reference SH31002P12F2000, the complete nameplate, shaft, encoder, brake, connectors, sealing, cable set, drive rating, and machine project. Matching only SH100/40060 is not sufficient.