ELAU SH070/60020/0/0/00/00/00/00/00 2.2Nm Smooth Shaft Singleturn No-Brake PacDrive Servo Motor

The ELAU SH070/60020/0/0/00/00/00/00/00 is a 70 mm-frame permanent-magnet three-phase synchronous servo motor for PacDrive motion systems. The SH070/60020 motor body provides 2.2 Nm standstill torque and 7.6 Nm peak torque. At the documented 400 V operating point, it delivers 1.9 Nm rated torque at 6000 rpm with 1.19 kW rated output.

This complete suffix identifies the smooth shaft, SinCos SKS36 singleturn absolute feedback, and a version without a holding brake, with angular round connectors. It is suited to compact high-cycle axes using a friction or clamp coupling where low rotor inertia and simple singleturn positioning are beneficial. This combination is distinct from other SH070/60020 variants: a smooth shaft, singleturn encoder, and no-brake configuration in the mid-size SH070 torque class. Use the full legacy type code and the mapped SH3 reference SH30702P01A2000 when checking a replacement.

Key Features

· 2.2 Nm standstill torque and 7.6 Nm peak torque for dynamic PacDrive axes

· 1.19 kW rated output at the documented 400 V operating point

· Smooth shaft for the specified mechanical coupling arrangement

· SinCos SKS36 singleturn absolute feedback for motor commutation and position control

· Without holding brake to match the machine's load-holding design

· Mapped SH3 reference SH30702P01A2000 helps verify the exact legacy configuration

Typical Applications

· Fast product-feed axes

· Labeling and registration mechanisms

· Small rotary cutters

· Light conveyor and transfer stations

· Replacement in compact PacDrive SH070/60020 axes

Compatibility and Selection Note

Select the motor by the complete type code SH070/60020/0/0/00/00/00/00/00, not only by SH070/60020. Confirm the shaft interface, encoder type, brake, connector orientation, sealing, motor cable, drive current rating, controller project, and machine mounting arrangement. The mapped reference SH30702P01A2000 supports configuration checking but does not remove the need to compare the installed nameplate and connector layout. Do not substitute another suffix without checking mechanical fit, feedback compatibility, and brake wiring.

FAQ

What separates this model from SH070/60010?

SH070/60020 provides 2.2 Nm standstill torque and 7.6 Nm peak torque, giving more load capacity than the smaller SH070/60010 while retaining the 70 mm frame.

Which shaft configuration does this exact model use?

It uses a smooth shaft. The coupling, hub, key, axial retention, and permitted shaft loads must match this mechanical version.

What feedback device is specified?

The exact configuration uses SinCos SKS36 singleturn absolute feedback. The controller project and feedback interface must be checked before replacement.

Does this model include a holding brake?

No. This exact suffix does not include a holding brake. The machine must provide a safe means of retaining any gravity-loaded or mechanically unstable axis.

Can this SH motor operate without a compatible servo drive?

No. It is a synchronous servo motor and requires a compatible PacDrive servo amplifier, correctly sized motor cable, feedback connection, motor data, and controller configuration.

What should be verified before ordering a replacement?

Compare SH070/60020/0/0/00/00/00/00/00, cross reference SH30702P01A2000, the complete nameplate, shaft, encoder, brake, connectors, sealing, cable set, drive rating, and machine project. Matching only SH070/60020 is not sufficient.