ELAU SH070/60030/0/0/00/00/00/11/00 3.1Nm Smooth Shaft Multiturn Brake PacDrive Servo Motor

The ELAU SH070/60030/0/0/00/00/00/11/00 is a 70 mm-frame permanent-magnet three-phase synchronous servo motor for PacDrive motion systems. The SH070/60030 motor body provides 3.1 Nm standstill torque and 11.3 Nm peak torque. At the documented 400 V operating point, it delivers 2.3 Nm rated torque at 6000 rpm with 1.45 kW rated output.

This complete suffix identifies the smooth shaft, SinCos SKM36 multiturn absolute feedback, and a version with a holding brake, with angular round connectors. It is suited to compact axes requiring the highest SH070 torque in this batch, absolute multiturn position retention, and a holding brake. This combination is distinct from other SH070/60030 variants: the SH070/60030 torque body combined with smooth shaft, multiturn feedback, and brake. Use the full legacy type code and the mapped SH3 reference SH30703P02F2000 when checking a replacement.

Key Features

· 3.1 Nm standstill torque and 11.3 Nm peak torque for dynamic PacDrive axes

· 1.45 kW rated output at the documented 400 V operating point

· Smooth shaft for the specified mechanical coupling arrangement

· SinCos SKM36 multiturn absolute feedback for motor commutation and position control

· Holding brake included to match the machine's load-holding design

· Mapped SH3 reference SH30703P02F2000 helps verify the exact legacy configuration

Typical Applications

· Vertical compact positioning axes

· Multi-position cartoning mechanisms

· Format-change and adjustment axes

· High-cycle cutting and sealing equipment

· Replacement of SH070/60030 brake configurations

Compatibility and Selection Note

Select the motor by the complete type code SH070/60030/0/0/00/00/00/11/00, not only by SH070/60030. Confirm the shaft interface, encoder type, brake, connector orientation, sealing, motor cable, drive current rating, controller project, and machine mounting arrangement. The mapped reference SH30703P02F2000 supports configuration checking but does not remove the need to compare the installed nameplate and connector layout. Do not substitute another suffix without checking mechanical fit, feedback compatibility, and brake wiring.

FAQ

What makes this version different from a singleturn SH070/60030?

The multiturn encoder preserves position information across multiple shaft revolutions, while the holding brake supports stationary load retention after motion stops.

Which shaft configuration does this exact model use?

It uses a smooth shaft. The coupling, hub, key, axial retention, and permitted shaft loads must match this mechanical version.

What feedback device is specified?

The exact configuration uses SinCos SKM36 multiturn absolute feedback. The controller project and feedback interface must be checked before replacement.

Does this model include a holding brake?

Holding brake included. A holding brake is intended for stationary load retention and is not a service brake for repeatedly stopping a moving axis.

Can this SH motor operate without a compatible servo drive?

No. It is a synchronous servo motor and requires a compatible PacDrive servo amplifier, correctly sized motor cable, feedback connection, motor data, and controller configuration.

What should be verified before ordering a replacement?

Compare SH070/60030/0/0/00/00/00/11/00, cross reference SH30703P02F2000, the complete nameplate, shaft, encoder, brake, connectors, sealing, cable set, drive rating, and machine project. Matching only SH070/60030 is not sufficient.