ELAU iSH100/30058/0/1/00/0/00/10/00 5.8Nm Keyed Shaft Multiturn Integrated Servo Motor

The ELAU iSH100/30058/0/1/00/0/00/10/00 is a decentralized PacDrive iSH servo module that combines a synchronous motor, power stage, digital servo controller, feedback system, and electronic type plate in one motor-mounted assembly. Its iSH100/30058 motor body provides 5.8 Nm standstill torque and 28.3 Nm peak torque, with 3.5 Nm rated torque at 3000 rpm and 1.1 kW rated output.

This exact suffix specifies the keyed shaft, SinCos SKM36 multiturn absolute feedback, without a holding brake, and no shaft seal, IP54 shaft side except IP40 in IM V3, IP65 housing. The configuration supports higher-torque decentralized axes requiring a keyed load connection and multiturn position tracking without a holding brake. It differs from other iSH100/30058 pages through the largest iSH100 torque body in this batch with keyed shaft and multiturn feedback. Reference VIA1003C12A0000 may also appear on the type plate or in installed-system records, but the complete iSH type code remains the primary selection key.

Key Features

· Motor, power amplifier, servo controller, and electronic type plate integrated at the axis

· 5.8 Nm standstill torque with 3000 rpm rated speed

· Keyed shaft and no shaft seal, IP54 shaft side except IP40 in IM V3, IP65 housing

· SinCos SKM36 multiturn absolute feedback for decentralized position control

· Without holding brake in the exact encoder-brake configuration

· Hybrid connection reduces separate cabinet drive hardware and axis cabling

Typical Applications

· Distributed conveyor and roller drives

· Keyed indexing mechanisms

· Multi-revolution positioning axes

· Packaging line transfer modules

· Replacement of iSH100/30058 integrated axes

Compatibility and Selection Note

This model belongs to the legacy PacDrive iSH architecture and must be matched by the complete code iSH100/30058/0/1/00/0/00/10/00. Confirm PS-5 and DB-5 system compatibility, hybrid cable pinout, SERCOS topology, controller project, DC bus, 24 V control supply, shaft interface, sealing, encoder type, brake wiring, and optional-module code. A separate SH motor or a different iSH suffix is not a direct substitute. Compare the installed type plate and reference VIA1003C12A0000 before order.

FAQ

Why use multiturn feedback on this no-brake model?

Multiturn feedback helps the controller recover absolute position over multiple revolutions. It does not replace a mechanical brake, so the machine must manage any load that can move when power is removed.

Which shaft configuration does this exact model use?

It uses a keyed shaft. The coupling, hub, key, axial retention, and permitted shaft loads must match this mechanical version.

What feedback device is specified?

The exact configuration uses SinCos SKM36 multiturn absolute feedback. The controller project and feedback interface must be checked before replacement.

Does this model include a holding brake?

No. This exact suffix does not include a holding brake. The machine must provide a safe means of retaining any gravity-loaded or mechanically unstable axis.

Is this iSH model only a motor?

No. The iSH assembly integrates the motor, power stage, digital servo controller, feedback, and electronic type plate. It operates within the matching PacDrive iSH power and communication system.

What should be verified before ordering a replacement?

Compare iSH100/30058/0/1/00/0/00/10/00, reference VIA1003C12A0000, shaft, sealing, encoder, brake, hybrid connector, PS-5 and DB-5 architecture, SERCOS layout, firmware, and controller project. The complete suffix must match.