ELAU SH100/50030/0/0/00/00/00/01/00 3.3Nm 5000rpm Smooth Shaft Brake PacDrive Servo Motor

The ELAU SH100/50030/0/0/00/00/00/01/00 is a 100 mm-frame permanent-magnet three-phase synchronous servo motor for PacDrive motion systems. The SH100/50030 motor body provides 3.3 Nm standstill torque and 9.6 Nm peak torque. At the documented 400 V operating point, it delivers 2.7 Nm rated torque at 5000 rpm with 1.41 kW rated output.

This complete suffix identifies the smooth shaft, SinCos SKS36 singleturn absolute feedback, and a version with a holding brake, with angular round connectors. It is suited to moderate-torque axes needing a 5000 rpm winding, a smooth coupling interface, and a brake without requiring multiturn feedback. This combination is distinct from other SH100/50030 variants: the 5000 rpm SH100 winding with singleturn feedback and holding brake. Use the full legacy type code and the mapped SH3 reference SH31001P01F2000 when checking a replacement.

Key Features

· 3.3 Nm standstill torque and 9.6 Nm peak torque for dynamic PacDrive axes

· 1.41 kW rated output at the documented 400 V operating point

· Smooth shaft for the specified mechanical coupling arrangement

· SinCos SKS36 singleturn absolute feedback for motor commutation and position control

· Holding brake included to match the machine's load-holding design

· Mapped SH3 reference SH31001P01F2000 helps verify the exact legacy configuration

Typical Applications

· Vertical feeder and loader axes

· Moderate-speed winding mechanisms

· Packaging and filling machinery

· Servo-driven adjustment stations

· Replacement in matching SH100/50030 installations

Compatibility and Selection Note

Select the motor by the complete type code SH100/50030/0/0/00/00/00/01/00, not only by SH100/50030. Confirm the shaft interface, encoder type, brake, connector orientation, sealing, motor cable, drive current rating, controller project, and machine mounting arrangement. The mapped reference SH31001P01F2000 supports configuration checking but does not remove the need to compare the installed nameplate and connector layout. Do not substitute another suffix without checking mechanical fit, feedback compatibility, and brake wiring.

FAQ

How does the 5000 rpm winding affect selection?

The SH100/50030 has a higher rated speed than the SH100/40060 and SH100/40080 bodies. Drive sizing and machine speed requirements must be checked against the exact motor data.

Which shaft configuration does this exact model use?

It uses a smooth shaft. The coupling, hub, key, axial retention, and permitted shaft loads must match this mechanical version.

What feedback device is specified?

The exact configuration uses SinCos SKS36 singleturn absolute feedback. The controller project and feedback interface must be checked before replacement.

Does this model include a holding brake?

Holding brake included. A holding brake is intended for stationary load retention and is not a service brake for repeatedly stopping a moving axis.

Can this SH motor operate without a compatible servo drive?

No. It is a synchronous servo motor and requires a compatible PacDrive servo amplifier, correctly sized motor cable, feedback connection, motor data, and controller configuration.

What should be verified before ordering a replacement?

Compare SH100/50030/0/0/00/00/00/01/00, cross reference SH31001P01F2000, the complete nameplate, shaft, encoder, brake, connectors, sealing, cable set, drive rating, and machine project. Matching only SH100/50030 is not sufficient.