ELAU iSH100/30044/0/0/00/0/00/01/00 4.4Nm Smooth Shaft Singleturn Brake Integrated Servo Motor

The ELAU iSH100/30044/0/0/00/0/00/01/00 is a decentralized PacDrive iSH servo module that combines a synchronous motor, power stage, digital servo controller, feedback system, and electronic type plate in one motor-mounted assembly. Its iSH100/30044 motor body provides 4.4 Nm standstill torque and 18.3 Nm peak torque, with 2.9 Nm rated torque at 3000 rpm and 0.91 kW rated output.

This exact suffix specifies the smooth shaft, SinCos SKS36 singleturn absolute feedback, with a holding brake, and no shaft seal, IP54 shaft side except IP40 in IM V3, IP65 housing. The configuration supports decentralized vertical or position-retaining axes that use a smooth coupling and need a holding brake without multiturn feedback. It differs from other iSH100/30044 pages through the /01 encoder-brake code, which specifies singleturn feedback with a holding brake. Reference VIA1002C01F0000 may also appear on the type plate or in installed-system records, but the complete iSH type code remains the primary selection key.

Key Features

· Motor, power amplifier, servo controller, and electronic type plate integrated at the axis

· 4.4 Nm standstill torque with 3000 rpm rated speed

· Smooth shaft and no shaft seal, IP54 shaft side except IP40 in IM V3, IP65 housing

· SinCos SKS36 singleturn absolute feedback for decentralized position control

· Holding brake included in the exact encoder-brake configuration

· Hybrid connection reduces separate cabinet drive hardware and axis cabling

Typical Applications

· Vertical decentralized positioning axes

· Cartoning and loading mechanisms

· Smooth-coupled feed rollers

· Compact material-handling modules

· Replacement of matching iSH100/30044 brake motors

Compatibility and Selection Note

This model belongs to the legacy PacDrive iSH architecture and must be matched by the complete code iSH100/30044/0/0/00/0/00/01/00. Confirm PS-5 and DB-5 system compatibility, hybrid cable pinout, SERCOS topology, controller project, DC bus, 24 V control supply, shaft interface, sealing, encoder type, brake wiring, and optional-module code. A separate SH motor or a different iSH suffix is not a direct substitute. Compare the installed type plate and reference VIA1002C01F0000 before order.

FAQ

What does the final /01 configuration provide?

It identifies singleturn SinCos feedback together with a holding brake. The complete suffix must be retained because other iSH100/30044 versions use different encoder and brake combinations.

Which shaft configuration does this exact model use?

It uses a smooth shaft. The coupling, hub, key, axial retention, and permitted shaft loads must match this mechanical version.

What feedback device is specified?

The exact configuration uses SinCos SKS36 singleturn absolute feedback. The controller project and feedback interface must be checked before replacement.

Does this model include a holding brake?

Holding brake included. A holding brake is intended for stationary load retention and is not a service brake for repeatedly stopping a moving axis.

Is this iSH model only a motor?

No. The iSH assembly integrates the motor, power stage, digital servo controller, feedback, and electronic type plate. It operates within the matching PacDrive iSH power and communication system.

What should be verified before ordering a replacement?

Compare iSH100/30044/0/0/00/0/00/01/00, reference VIA1002C01F0000, shaft, sealing, encoder, brake, hybrid connector, PS-5 and DB-5 architecture, SERCOS layout, firmware, and controller project. The complete suffix must match.