ELAU SH100/40060/0/0/00/00/00/11/00 5.8Nm Smooth Shaft Multiturn Brake PacDrive Servo Motor

The ELAU SH100/40060/0/0/00/00/00/11/00 is a 100 mm-frame permanent-magnet three-phase synchronous servo motor for PacDrive motion systems. The SH100/40060 motor body provides 5.8 Nm standstill torque and 18.3 Nm peak torque. At the documented 400 V operating point, it delivers 4.6 Nm rated torque at 4000 rpm with 1.93 kW rated output.

This complete suffix identifies the smooth shaft, SinCos SKM36 multiturn absolute feedback, and a version with a holding brake, with angular round connectors. It is suited to position-controlled axes that use a clamp-style coupling and must retain their mechanical position when power is removed. This combination is distinct from other SH100/40060 variants: a smooth shaft together with multiturn feedback and a holding brake. Use the full legacy type code and the mapped SH3 reference SH31002P02F2000 when checking a replacement.

Key Features

· 5.8 Nm standstill torque and 18.3 Nm peak torque for dynamic PacDrive axes

· 1.93 kW rated output at the documented 400 V operating point

· Smooth shaft for the specified mechanical coupling arrangement

· SinCos SKM36 multiturn absolute feedback for motor commutation and position control

· Holding brake included to match the machine's load-holding design

· Mapped SH3 reference SH31002P02F2000 helps verify the exact legacy configuration

Typical Applications

· Vertical lifting and positioning axes

· Cartoning and case-packing stations

· Registration axes that retain absolute position

· Printing and converting machinery

· Replacement in installed PacDrive SH100/40060 axes

Compatibility and Selection Note

Select the motor by the complete type code SH100/40060/0/0/00/00/00/11/00, not only by SH100/40060. Confirm the shaft interface, encoder type, brake, connector orientation, sealing, motor cable, drive current rating, controller project, and machine mounting arrangement. The mapped reference SH31002P02F2000 supports configuration checking but does not remove the need to compare the installed nameplate and connector layout. Do not substitute another suffix without checking mechanical fit, feedback compatibility, and brake wiring.

FAQ

How does this model differ from a no-brake SH100/40060 version?

This exact /11 configuration combines multiturn feedback with a holding brake. A no-brake version does not provide the same static holding function when motor power is removed.

Which shaft configuration does this exact model use?

It uses a smooth shaft. The coupling, hub, key, axial retention, and permitted shaft loads must match this mechanical version.

What feedback device is specified?

The exact configuration uses SinCos SKM36 multiturn absolute feedback. The controller project and feedback interface must be checked before replacement.

Does this model include a holding brake?

Holding brake included. A holding brake is intended for stationary load retention and is not a service brake for repeatedly stopping a moving axis.

Can this SH motor operate without a compatible servo drive?

No. It is a synchronous servo motor and requires a compatible PacDrive servo amplifier, correctly sized motor cable, feedback connection, motor data, and controller configuration.

What should be verified before ordering a replacement?

Compare SH100/40060/0/0/00/00/00/11/00, cross reference SH31002P02F2000, the complete nameplate, shaft, encoder, brake, connectors, sealing, cable set, drive rating, and machine project. Matching only SH100/40060 is not sufficient.