ELAU SH140/30330/0/0/00/00/00/11/00 33.4Nm High-Torque Multiturn Brake PacDrive Servo Motor

The ELAU SH140/30330/0/0/00/00/00/11/00 is a 140 mm-frame permanent-magnet three-phase synchronous servo motor for PacDrive motion systems. The SH140/30330 motor body provides 33.4 Nm standstill torque and 131.9 Nm peak torque. At the documented 400 V operating point, it delivers 16.1 Nm rated torque at 3000 rpm with 5.06 kW rated output.

This complete suffix identifies the smooth shaft, SinCos SKM36 multiturn absolute feedback, and a version with a holding brake, with angular round connectors. It is suited to high-torque machine axes where absolute position retention and controlled load holding are more important than minimum motor mass. This combination is distinct from other SH140/30330 variants: the largest SH140 torque class in this batch, paired with a smooth shaft, multiturn encoder, and brake. Use the full legacy type code and the mapped SH3 reference SH31404P02F2000 when checking a replacement.

Key Features

· 33.4 Nm standstill torque and 131.9 Nm peak torque for dynamic PacDrive axes

· 5.06 kW rated output at the documented 400 V operating point

· Smooth shaft for the specified mechanical coupling arrangement

· SinCos SKM36 multiturn absolute feedback for motor commutation and position control

· Holding brake included to match the machine's load-holding design

· Mapped SH3 reference SH31404P02F2000 helps verify the exact legacy configuration

Typical Applications

· Heavy indexing and transfer axes

· Large web-handling and winding systems

· High-load packaging machinery

· Press-feed and converting equipment

· Replacement of high-torque PacDrive SH140 axes

Compatibility and Selection Note

Select the motor by the complete type code SH140/30330/0/0/00/00/00/11/00, not only by SH140/30330. Confirm the shaft interface, encoder type, brake, connector orientation, sealing, motor cable, drive current rating, controller project, and machine mounting arrangement. The mapped reference SH31404P02F2000 supports configuration checking but does not remove the need to compare the installed nameplate and connector layout. Do not substitute another suffix without checking mechanical fit, feedback compatibility, and brake wiring.

FAQ

Why is the SH140/30330 selected for heavier axes?

Its 33.4 Nm standstill torque and 131.9 Nm peak torque provide substantially more torque capacity than the smaller SH070 and SH100 motors in this batch.

Which shaft configuration does this exact model use?

It uses a smooth shaft. The coupling, hub, key, axial retention, and permitted shaft loads must match this mechanical version.

What feedback device is specified?

The exact configuration uses SinCos SKM36 multiturn absolute feedback. The controller project and feedback interface must be checked before replacement.

Does this model include a holding brake?

Holding brake included. A holding brake is intended for stationary load retention and is not a service brake for repeatedly stopping a moving axis.

Can this SH motor operate without a compatible servo drive?

No. It is a synchronous servo motor and requires a compatible PacDrive servo amplifier, correctly sized motor cable, feedback connection, motor data, and controller configuration.

What should be verified before ordering a replacement?

Compare SH140/30330/0/0/00/00/00/11/00, cross reference SH31404P02F2000, the complete nameplate, shaft, encoder, brake, connectors, sealing, cable set, drive rating, and machine project. Matching only SH140/30330 is not sufficient.